TDEE Calculator

Use this free TDEE & Macro Calculator to estimate how many calories you burn per day, your maintenance calories, and simple targets for fat loss, lean bulking and daily protein. It takes about 30 seconds and works in metric or imperial units.

TDEE & Macro Calculator

Uses the Mifflin-St Jeor equation. Results are estimates for educational use only, not medical advice. Track your weight for 2–3 weeks and adjust.

How This Calculator Works

The calculator runs a simple two-step engineering model:

  1. BMR (Basal Metabolic Rate): the energy your body uses at complete rest, estimated with the Mifflin-St Jeor equation. Men: (10 × weight in kg) + (6.25 × height in cm) − (5 × age) + 5. Women: the same formula, but − 161 instead of + 5.
  2. TDEE (Total Daily Energy Expenditure): BMR multiplied by an activity factor from 1.2 (sedentary) to 1.9 (very high).

From your TDEE, the calculator suggests a fat-loss target (about 500 kcal below maintenance), a lean-bulk target (about 300 kcal above), and a protein range of 1.6–2.2 g per kg of body weight.

Why Your Result Is a Starting Point

Every formula has error. A BMR equation can be off by around 10% for an individual, and most people overestimate their activity level. Treat this number as your first estimate, then calibrate it with real data: log your calories, weigh yourself every morning, and compare your 7-day average weight over 2–3 weeks.

I explain the full calibration method step by step, with worked examples, in How to Calculate Your TDEE Accurately: An Engineer's Guide.

Tips for an Accurate Result

  • Weigh yourself in the morning, after using the bathroom and before eating.
  • Choose the lower activity level if you are between two options.
  • Don't count your smartwatch calories on top of the activity factor.
  • Recalculate after every 4–5 kg of weight change.

This calculator is for educational purposes only and is not medical advice. Read the full Disclaimer.

Comments

Popular posts from this blog

Caffeine as a Turbocharger: Adenosine Antagonism, Half-Life Decay, and System Performance

Warm-Up as Machine Ramp-Up: The Engineering of Startup Curves and Joint Preparation

Periodization as Production Planning: Aggregate Planning, MPS, and Mesocycles for Lifters